Bullwhip Belly and Bolster

Bullwhip Belly and Bolster

One thing that I used to do and stopped doing when making whips was that I used to cut out all the internal layers at the same time, before I did any plaiting.  I don’t know why I stopped doing this, however recently I starting doing it again and it’s a huge time saver!  I also find it’s easier to do one task several times than to constantly switch my brain to doing different things.

So for the whip I’m currently working on I cut out the core, bellies and bolsters before I did any plaiting.  When I used to do this people would ask me how I knew how wide to cut everything.  It’s pretty easy since everything is going to be approximately the same thickness withing fractions of a millimeter.  I cut the bolsters a little bit wider, then tweak them when it’s time to put them onto the whip.

Here’s the whip I’m currently working on, this is the inner belly completed.


This whip has a spring steel handle.  With the handle I think spring steel is the way to go over just a steel rod. The reason is that normal steel can be bent and spring steel cannot (except under very extreme circumstances).

Today I’ll finish up the interior layers of this whip and then move on to the cutting out the overlay.


Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.