Signal Whip in Progress…

Signal Whip in Progress…

Right now I’m working on a two 12 plait kangaroo signal whips.  They are both black and 4 feet long. I guess you could call them a pair because I’m making them the same way, at the same time from the same hide…except one is for an order and one will be listed for sale on my IN STOCK Whips page when it’s finished.

I’m making two signal whips instead of just one because it’s not too much extra work to do a second one at the same time.  Also I can get two 4 foot signal whips out of one kangaroo hide.  If I made one signal whip out of the 61dm kangaroo skin, the rest wouldn’t be enough for much more than another signal whip, so might as well make it.

Yesterday morning I filled the shot bags, plaited both bellies and attached the bolsters:

single tail singal whip's shot loaded core

Then I cut out the two 12 plait kangaroo overlays:

12 plait kangaroo strands for a signal whip

I also did all the strand prep for one of the whips and have about a foot of it braided.  I should be able to finish this whip today.

Thoughts on Preparing the Strands for Braiding

Yesterday while I was doing the strand prep on one of these 12 plait sets, I thought about everything that goes into getting the strands ready to braid.

To make a whips all you really need to do is cut out the strands and start braiding.  That will make a pretty rough looking whip, but you can do it.  All the other stuff will improve the tightness of the braid, and look of the whip.

Right now my process is:

  • Grease (optional): Some kangaroo hides are dryer than others, and strands cut from a dry hide will stretch better if you grease it and let the grease soak in before you do anything else.  If the hide is nice and greasy this step is unnecessary.
  • Stretch: The initial stretch takes most of the stretch out of the lace.   Also it will hopefully let you know of any weak spots before you start braiding.
  • Straighten: Since I cut by hand and cut stretchy parts a bit wider than they need to be, I straighten out my strands by running them through my David Morgan Lace Cutter.
  • Pare: Having two of the corners beveled will help me get a bit of a tighter braid and give the whip a smoother look.
  • Stretch: After straightening an paring, parts of the strands may not have been fully stretched because of the parts that were cut off.  For me this second stretch is more of a strand strength test, but will also take more of the stretch out of the lace.
  • Split:  This evens out the strand’s thickness and gives me a more uniform strand to work with.  Throughout the kangaroo skin, the thickness can vary a bit, maybe .1mm, but that when braided will add .4 mm of extra thickenss to the whip at that point and could result in a small lump.

My strand prep has gotten a lot more involved than it was three years ago when I just stretched and pared.  In the end I think it helps


2 thoughts on “Signal Whip in Progress…

Leave a Reply

Your email address will not be published. Required fields are marked *